Assemble Procedure
WARNING: This page is about a different variant/trim than selected.
Use lubricant included with the EN-46122 Camshaft Position Actuator Check-Ball Valve Remover/Installer to lubricate outside of NEW engine oil manifold check valve (1).
- With the check ball end of the check valve facing UP, away from the head, insert the NEW engine oil manifold check valve into the check valve bore in the camshaft carrier.
Place collar EN-46122 - 2 (1) over the NEW engine oil manifold check valve with the slightly-larger inside diameter of the collar DOWN toward the camshaft carrier.
- Using the driver EN-46122 - 1 (2), lightly tap the NEW engine oil manifold check valve into place until the driver stops against the top of the collar.
Inspect the engine oil manifold check valves in order to ensure they are properly installed in the camshaft carrier. The engine oil manifold check valves should be flush to 0.75 mm (0.0295 in) below the camshaft carrier deck surface (a).