Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Using the EN-37281-A Valve Guide Seal Remover, install the NEW valve seal. Fully seat the seal onto the valve guide.
Install the valve spring (3) and retainer (2).
- Compress the valve spring using the valve spring compressor.
- Install the valve spring keepers (1).
- Disconnect the air hose and remove the EN-35667-A Leakdown Adapter.
Remove the EN-50717 Valve Spring Compressor and EN-50717 Valve Spring Compressor adapter set from the cylinder head.
- Install the spark plugs. Gas Engine Ignition Spark Plug Replacement
- Valve Rocker Arm - Install - Valve Rocker Arm Replacement (Exhaust) , or Valve Rocker Arm Replacement (Intake)
- Install the camshaft. Camshaft Position Actuator and Intake Camshaft Replacement , Camshaft Position Actuator and Exhaust Camshaft Replacement
- Remove the EN-50792 Flywheel Holding Tool.
- If equipped with an automatic transmission, install the starter. Starter Replacement (LTG)