Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Lubricate the valve tips. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- NOTE:
- Used rocker arms must be returned to the original position on the camshaft. If the camshaft is being replaced, the rocker arms actuated by the camshaft must also be replaced.
- Pre-oil roller bearings before installation.
Lubricate the roller bearings with valve rocker arm lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Position the valve rocker arm (1) on the tip of the valve stem and on the lash adjuster and lubricate. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the camshaft position actuator and camshaft - exhaust. Refer to Camshaft Position Actuator and Exhaust Camshaft Replacement .