Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Install a NEW exhaust manifold gasket (2).
Install the exhaust manifold (1) to the cylinder head.
Hand start NEW exhaust manifold to cylinder head retaining bolts (3).
Fig 1: Exhaust Manifold Bolt Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.

Tighten the NEW exhaust manifold to cylinder head bolts three passes in sequence to 20 N.m (15 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the exhaust manifold brace (2).
Install the exhaust manifold brace bolts (3) and tighten to 25 N.m (18 lb ft)
Install NEW exhaust manifold brace nuts (1) and tighten to 25 N.m (18 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Install the exhaust manifold heat shield (1).
Install the exhaust manifold heat shield bolts (2) and tighten to 14 N.m (124 lb in).