LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 2.0L - Repair Instructions) >> Repair Instructions >> Engine Replacement (Manual Transmission) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
  2. Recover the refrigerant. Refrigerant Recovery and Recharging (R-134a) , or Refrigerant Recovery and Recharging (R-1234yf)
  3. Charge Air Cooler Inlet Air Tube Replacement - Remove
  4. Charge Air Cooler Outlet Air Tube Replacement - Remove
  5. Drain the cooling system. Cooling System Draining and Filling (GE 47716) , or Cooling System Draining and Filling (Static Fill)
  6. GM2876816Courtesy of GENERAL MOTORS COMPANY

    Intake Manifold Cover (1) - Remove - Intake Manifold Cover Replacement 

  7. GM2876751Courtesy of GENERAL MOTORS COMPANY

    Air Cleaner Assembly (1) - Remove - Air Cleaner Assembly Replacement

  8. Air Cleaner Outlet Duct (2) - Remove - Air Cleaner Outlet Duct Replacement (Non-Tamperproof) , or Air Cleaner Outlet Duct Replacement (Tamperproof)
  9. GM2876818Courtesy of GENERAL MOTORS COMPANY

    Radiator Surge Tank Inlet Hose (1) @Engine - Disconnect - Radiator Surge Tank Inlet Hose Replacement (LTG)

  10. Radiator Inlet Hose@Engine - Disconnect - Radiator Inlet Hose Replacement (LTG without V18) , or Radiator Inlet Hose Replacement (LTG with V18)
  11. Radiator Outlet Hose@Engine - Disconnect - Radiator Outlet Hose Replacement (LTG without V18) , or Radiator Outlet Hose Replacement (LTG with V18)
  12. Fuel Feed Pipe@Engine - Disconnect - Fuel Feed Pipe Replacement (At Fuel Injection Pump) , or Fuel Feed Pipe Replacement (Engine to Tank)
  13. GM4287765Courtesy of GENERAL MOTORS COMPANY

    Air Conditioning Compressor Hose (3) - Disconnect - Air Conditioning Compressor Hose Replacement (LTG with Y4Q) , or Air Conditioning Compressor Hose Replacement (LTG without Y4Q)

  14. Transmission Control Replacement (M13) - Remove
  15. Two-Piece Propeller Shaft Replacement (Coupe with LTG and M5T) , or Two-Piece Propeller Shaft Replacement (Convertible with LTG and M5T) - Remove
  16. Disconnect the hydraulic clutch hose/pipe from the transmission. Hydraulic Clutch Hose/Pipe Replacement (M13)
  17. GM4288982Courtesy of GENERAL MOTORS COMPANY

    Evaporative Emission Pipe (1) @Evaporative Emission Canister Purge Solenoid Valve@Disconnect - Plastic Collar Quick Connect Fitting Service

  18. Evaporative Emission Pipe (2) @Retainer - Reposition
  19. Engine Wiring Harness Junction Block Replacement - Remove
  20. Engine Control Module Bracket - Remove - Engine Control Module Bracket Replacement
  21. GM4290901Courtesy of GENERAL MOTORS COMPANY

    Remove the cap (1) from the ground stud nut.

  22. Remove the nut from the stud. (2)
  23. Disconnect the remaining engine wiring harness connectors then position the wiring harness (3) on top the engine.
  24. Disconnect the air conditioning pressure sensor electrical connector.
  25. Charge Air Cooler-Right Side - Remove - Charge Air Cooler Replacement - Right Side (LTG with V18)
  26. Charge Air Cooler-Left Side - Remove - Charge Air Cooler Replacement - Left Side (LTG with V18)
  27. GM4578723Courtesy of GENERAL MOTORS COMPANY

    Disconnect the ambient air temperature sensor harness retainers (1) Ambient Air Temperature Sensor Replacement (LGX LTG)

  28. Disconnect the ambient air temperature sensor (2).
  29. Heater Inlet Hose@Heater Core - Disconnect - Heater Inlet Hose Replacement (LTG)
  30. Heater Outlet Hose@Heater Core - Disconnect - Heater Outlet Hose Replacement (LTG)
  31. Disconnect the vacuum brake booster vacuum switch electrical connector.
  32. GM4170136Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Provide additional support when a vehicle is on a hoist in the following ways:

    • Before removing parts, support the opposite end. This helps prevent the vehicle from slipping off. 
    • Before removing major components, chain the vehicle frame to the hoist pads at the same end as the removal. This helps avoid a tip-off. 

    Failure to follow these precautions could cause vehicle damage, serious personal injury, or death.

    Power Brake Booster Vacuum Hose@Power Brake Booster - Disconnect - Power Brake Booster Vacuum Hose Replacement (LTG)

  33. Auxiliary Engine Oil Cooler - Remove - Auxiliary Engine Oil Cooler Replacement (LTG with Y4Q)
  34. Air Conditioning Compressor Hose@Air Conditioning Compressor - Disconnect - Air Conditioning Compressor Hose Replacement (LTG with Y4Q) , or Air Conditioning Compressor Hose Replacement (LTG without Y4Q)
  35. Strap the vehicle to the hoist.
  36. Ensure when raising the body the following items are clear from the frame:
    • Vacuum lines
    • Steering knuckles
    • Electrical wiring harnesses
  37. GM3817358Courtesy of GENERAL MOTORS COMPANY

    Ensure that the fuel pump connector (1) clears the body structure when removing the engine.

  38. Remove the drivetrain and front suspension frame with the powertrain attached. Drivetrain and Front Suspension Cradle Removal and Installation (LTG)
  39. Secure the powertrain to the support table using straps and binders.
  40. Separate the engine from the transmission. Transmission Replacement (M13 with LTG Engine)
  41. Disconnect the electrical connectors and detach the wiring harness as necessary.
scientia non olet · About LEMON Manuals