Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.

Catalytic Converter Gasket
Catalytic Converter Gasket@Exhaust Muffler Assembly
Drivetrain and Front Suspension Cradle Front Bolt [2x]
Drivetrain and Front Suspension Cradle Interior Bolt [2x]
Drivetrain and Front Suspension Cradle Rear Bolt [2x]
Front Lower Control Arm Front Bolt [2x]
Front Lower Control Arm Rear Bolt [2x]

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Oil Pump Flow Control Valve Heat Shield Replacement Intermediate Steering Shaft Replacement Carefully lower the drivetrain and front suspension cradle. Drivetrain and Front Suspension Cradle Removal and Installation (LTG)
1	Engine Mount Bracket Fastener [4x] CAUTION: Refer to Fastener Caution . NOTE: Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket bolt includes a pressed-on aluminum washer. Ensure the washer is in place and not damaged. Replace the bolt if the washer is damaged or missing. Tighten 58 N.m (43 lb ft)
2	Engine Mount Bracket NOTE: Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket includes pressed on spacers on the back side. Even though it is highly unlikely, the pressed on spacers may loosen and fall off during engine mount bracket removal. Ensure the spacers are in place before reinstalling an existing bracket.

Callout

Component Name

Preliminary Procedures

Oil Pump Flow Control Valve Heat Shield Replacement
Intermediate Steering Shaft Replacement
Carefully lower the drivetrain and front suspension cradle. Drivetrain and Front Suspension Cradle Removal and Installation (LTG)

Engine Mount Bracket Fastener [4x]

CAUTION:

Refer to Fastener Caution .

NOTE:

Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket bolt includes a pressed-on aluminum washer. Ensure the washer is in place and not damaged. Replace the bolt if the washer is damaged or missing.

Tighten
58 N.m (43 lb ft)

Engine Mount Bracket

NOTE:

Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket includes pressed on spacers on the back side. Even though it is highly unlikely, the pressed on spacers may loosen and fall off during engine mount bracket removal. Ensure the spacers are in place before reinstalling an existing bracket.