Turbocharger Component Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Callouts items in the following chart represent components shown in graphic above.
Turbocharger Component Removal
| Callout | Component Name |
|---|---|
| 1 | Turbocharger Heat Shield Bolt [3x]
NOTE:
In the event that a bolt breaks upon removal of components, perform an extraction of the broken bolt. |
| 2 | Turbocharger Heat Shield |
| 3 | Turbocharger Wastegate Actuator Arm Retainer |
| 4 | Turbocharger Wastegate Actuator Bolt [2x] |
| 5 | Turbocharger Wastegate Actuator |
| 6 | Turbocharger Coolant Return Pipe Bolt
NOTE:
One bolt retains the turbocharger coolant return pipe and the camshaft cover heat shield at the same location. |
| 7 | Turbocharger Coolant Return Pipe Bolt |
| 8 | Turbocharger Coolant Return Pipe Procedure Disconnect the turbocharger coolant return pipe from the air bleed hose. |
| 9 | Turbocharger Coolant Return Pipe Washer [2x]
NOTE:
DISCARD the washers. |
| 10 | Turbocharger Coolant Feed Pipe Bolt |
| 11 | Turbocharger Coolant Feed Pipe Bolt [2x] |
| 12 | Turbocharger Coolant Feed Pipe Procedure Disconnect the turbocharger coolant feed pipe hose from the engine oil cooler. |
| 13 | Turbocharger Coolant Feed Pipe Gasket
NOTE:
DISCARD the gasket. |
| 14 | Turbocharger Coolant Feed Pipe Washer [2x]
NOTE:
DISCARD the washers. |
| 15 | Turbocharger Wastegate Regulator Solenoid Valve Bolt |
| 16 | Turbocharger Wastegate Regulator Solenoid Valve Procedure Disconnect the turbocharger wastegate regulator solenoid valve hoses from the turbocharger. |
| 17 | Turbocharger Air Bypass Valve Solenoid Bolt [3x] |
| 18 | Turbocharger Air Bypass Valve Solenoid |