Camshaft Cover Component Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
1	Vacuum Pump Gasket NOTE: Use a NEW gasket.
2	Vacuum Pump
3	Vacuum Pump Bolt [2x] Tighten 10 N.m (89 lb in)
4	Vacuum Pump Bolt Tighten 10 N.m (89 lb in)
5	Camshaft Position Actuator Solenoid Valve - Exhaust
6	Camshaft Position Actuator Solenoid Valve Bolt Tighten 10 N.m (89 lb in)
7	Camshaft Position Actuator Solenoid Valve - Intake
8	Camshaft Position Actuator Solenoid Valve Bolt Tighten 10 N.m (89 lb in)
9	Ignition Coil [4x] Procedure Inspect the inside of the ignition coil rubber boot for a thin, even coat of grease. If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease evenly to the inside of the ignition coil rubber boot, up to a depth of 15 mm from the end of the boot. Refer to Adhesives, Fluids, Lubricants, and Sealers . Remove any excess grease from around the end of the boot, and ensure there is not an excessive amount within the boot.
10	Ignition Coil Bolt [4x] Tighten 10 N.m (89 lb in)
11	Engine Lift Front Bracket
12	Engine Lift Front Bracket Bolt [2x] Tighten 25 N.m (18 lb ft)
13	Engine Lift Rear Bracket
14	Engine Lift Rear Bracket Bolt [2x] Tighten 25 N.m (18 lb ft)
15	Oil Level Indicator
16	Camshaft Cover Heat Shield
17	Camshaft Cover Heat Shield Bolt [3x] NOTE: An additional bolt retains the camshaft cover heat shield and the turbocharger coolant return pipe. Tighten 10 N.m (89 lb in)
18	Engine Coolant Air Bleed Pipe Seal NOTE: Use NEW seal.
19	Engine Coolant Air Bleed Pipe
20	Engine Coolant Air Bleed Pipe Bolt Tighten 10 N.m (89 lb in)