Camshaft Cover Heat Shield Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Intake Manifold Cover Replacement Turbocharger Heat Shield Replacement
1	Camshaft Heat Shield Cover Fastener (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Heat Shield Cover Procedure Disconnect the camshaft position actuator solenoid valve. Unclip the wiring harness. NOTE: When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.

Callout

Component Name

Preliminary Procedures

Camshaft Heat Shield Cover Fastener (Qty: 4)

CAUTION:

Tighten
10 N.m (89 lb in)

Camshaft Heat Shield Cover

Procedure

NOTE:

When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.