Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Warm Up Three-Way Catalytic Converter Replacement (LH - LGX) , or Warm Up Three-Way Catalytic Converter Replacement (RH - LGX) Power Brake Booster Vacuum Hose@Vacuum Pump Pipe - Disconnect - Power Brake Booster Vacuum Hose Replacement (LGX)
1	Engine Wiring Harness Procedure Unclip the engine wiring harness from the vacuum pump pipe bracket.
2	Vacuum Pump Pipe Bolt[2x] Procedure CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
3	Vacuum Pump Pipe
4	Vacuum Pump Pipe Seal Procedure NOTE: Lubricate the NEW O-ring seals with clean engine oil. Install a NEW seal.