Cleaning Procedure
WARNING: This page is about a different variant/trim than selected.
Fuel Injector Wiring Harness(1) - Disconnect
Taking care not to touch or apply force to the injector tip or electrical connector, remove the fuel injector (1) by pressing down on the retainer lever to release the tab (2) and simultaneously rotating the injector 45 degrees and pulling straight out from the fuel rail.
- Remove and DISCARD the fuel injector retainer (3) from the fuel injector.
Using pliers, remove and DISCARD the fuel injector bushing (3) straight out from injector body.
- Remove and DISCARD the fuel injection fuel rail seal (1) and plastic spacers (2).
- Fuel Injector Nozzle Housing Seal(4) - Remove and DISCARD(x2)
- NOTE:
Applying force to the plastic housing of the sensor will destroy the sensor. To tighten or loosen, only apply force to the attached hexagon.
Fuel Pressure Sensor(1) - Remove
- Clean the exterior of the fuel rail and injectors with solvent.
NOTE:
Do not soak or submerge the fuel rail or injectors in solvent.