Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Evaporative Emission Canister Hose (1) @ Retainer (3) - Install
- Evaporative Emission Canister Hose (1) @ Evaporative Emission Canister (2) - Connect - Plastic Collar Quick Connect Fitting Service
Evaporative Emission Canister Hose (1) @ Fuel Tank Filler Pipe (2) - Connect - Plastic Collar Quick Connect Fitting Service
Tie Strap (1) @ Evaporative Emission Canister Hose (2) - Install NEW [2x]
- Fuel Tank Pressure Sensor Replacement - Install
- Rear Wheelhouse Liner Replacement , or Rear Wheelhouse Liner Replacement (ZL1) - Install
Evaporative Emission Canister Hose (1) @ Fuel Tank Vent Valve Hose(2) - Connect - Plastic Collar Quick Connect Fitting Service
- Lower the vehicle.