Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
Always install the camshaft position sensor O-ring (3) supplied with the NEW camshaft position sensor. If reinstalling the sensor, inspect the camshaft position sensor O-ring (3) and replace as necessary. Lubricate the camshaft position sensor O-ring (3) with clean engine oil prior to installing the camshaft position sensor.
Camshaft Position Sensor(2) - Install
- Camshaft Position Sensor Bolt(1) - Install and tighten10 N.m (89 lb in).
Camshaft Position Sensor Electrical Connector(1)@Camshaft Position Sensor(2) - Connect
- Camshaft Housing Cover Insulator Replacement - Right Side - Install
CAUTION:
Refer to Fastener Caution .