Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Air Cleaner Outlet Duct - Remove - Air Cleaner Outlet Duct Replacement
Courtesy of GENERAL MOTORS COMPANY

Retainer(1) - Remove[2x]
Engine Wiring Harness(2) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector(1) - Disconnect
Camshaft Position Actuator Locating Pin Control Valve Bolt(2) - Remove
Camshaft Position Actuator Locating Pin Control Valve(3) - Remove
Inspect the camshaft position actuator solenoid valve seal (4) and replace as necessary.