Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Use EN-46103 Camshaft Actuator Valve Seal Installer to install the seal if replacement is necessary.
- Camshaft Position Actuator Locating Pin Control Valve(3) - Install
- Camshaft Position Actuator Locating Pin Control Valve Bolt(2) - Install and tighten10 N.m (89 lb in)
- Electrical Connector(1) - Connect
Engine Wiring Harness(2) - Reposition
- Retainer(1) - Install[2x]
- Air Cleaner Outlet Duct - Install - Air Cleaner Outlet Duct Replacement
CAUTION:
Refer to Fastener Caution .