Turbocharger Wastegate Actuator Replacement
WARNING: This page is about a different variant/trim than selected.
NOTE:
Callouts items in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Turbocharger Heat Shield Replacement |
|
| 1 | Turbocharger Wastegate Actuator Arm Retainer |
| 2 | Turbocharger Wastegate Actuator Fastener [2x]
CAUTION:
Refer to Fastener Caution . Tighten 20 N.m (15 lb ft) |
| 3 | Turbocharger Wastegate Actuator Procedure Disconnect the vacuum line from the turbocharger wastegate actuator. |