Turbocharger Bypass Valve Solenoid Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedure Air Cleaner Assembly Replacement
1	Turbocharger Bypass Valve Solenoid Bolt [3x] CAUTION: Refer to Fastener Caution . Tighten 7.8 N.m (69 lb in)
2	Turbocharger Bypass Valve Solenoid Procedure Disconnect the electrical connector. Inspect the turbocharger bypass valve solenoid seal and replace if necessary. Perform the intake system learned values reset. Intake System Learned Values Reset

Callout

Component Name

Turbocharger Bypass Valve Solenoid Bolt [3x]

CAUTION:

Tighten
7.8 N.m (69 lb in)

Turbocharger Bypass Valve Solenoid

Procedure

Disconnect the electrical connector.
Inspect the turbocharger bypass valve solenoid seal and replace if necessary.
Perform the intake system learned values reset. Intake System Learned Values Reset