Camshaft Position Actuator Intake Solenoid Valve Replacement

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedure Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
1	Camshaft Position Actuator Intake Solenoid Valve Fastener CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Actuator Intake Solenoid Valve NOTE: Inspect the Camshaft Position Actuator Intake Solenoid Valve O-ring seals. If damaged, replace the Camshaft Position Actuator Intake Solenoid Valve assembly. Procedure Disconnect the electrical wiring harness connector from the camshaft position actuator intake solenoid valve.