Park - Engine Running (Mechanical Powerflow): Notes

WARNING: This page is about a different variant/trim than selected.

Note: The component callouts in the text refer to the component callout numbers in disassembled views. Disassembled Views (10L60)Disassembled Views (10L80)Disassembled Views (10L90)

The transmission is in the park position. The park pawl actuator assembly (602) engages the park pawl (614) with the lugs on the output carrier assembly (73). The output carrier assembly (38) is held stationary, preventing the vehicle from moving.

1. Power from Torque Converter

The power flows through the turbine shaft (568) into the output sun gear (70). Powerflow continues through the input carrier (62) which drives the direct overdrive sun gear shaft (65) and direct overdrive sun gear (68). The direct overdrive sun gear drives the direct overdrive carrier (67) pinion gears.

2. 4-5-6-7-8-9-10 Reverse Clutch Assembly Applied

The 4-5-6-7-8-9-10 reverse clutch assembly is applied and holds the Output Carrier Internal Gear Transfer Shell (71).

3. Powerflow Terminated

The turbine shaft (568), output sun gear (70), input carrier (62), direct overdrive sun gear shaft (65), direct overdrive sun gear (68) and direct overdrive carrier (67) rotate freely, powerflow is terminated.

4. Vehicle Held Stationary

With the park pawl (614) engaged, the vehicle cannot move forward or backward.

5. 1-2-8-9-10 Reverse Clutch

The 1-2-8-9-10 reverse clutch is applied in park in preparation for a shift into either 1st or reverse. This aids shift timing as only one clutch will need to be applied to achieve either range. The 10 Speed RWD is designed to have four components applied for each gear range, Also in each forward range, the design includes that only one component will need to be applied as another component releases.

6. 1-2-3-4-5-6 Reverse Clutch

The 1-2-3-4-5-6 reverse clutch is applied in park in preparation for a shift into either 1st or reverse. This aids shift timing as only one clutch will need to be applied to achieve either range. The 10 Speed RWD is designed to have four components applied for each gear range, Also in each forward range, the design includes that only one component will need to be applied as another component releases.