Rear Differential Clutch Control Module Replacement (226 mm eLSD)

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedure Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle (ZL1) , or Lifting and Jacking the Vehicle (Convertible) . Disconnect the wiring harness connector before removal.
1	Rear Differential Clutch Control Module Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 6 N.m (53 lb in)
2	Rear Differential Clutch Control Module Procedure After the rear differential clutch control module has been replaced it must to be programmed. Refer to Control Module References .

Callout

Component Name

Preliminary Procedure

Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle (ZL1) , or Lifting and Jacking the Vehicle (Convertible) .
Disconnect the wiring harness connector before removal.

Rear Differential Clutch Control Module Bolt (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
6 N.m (53 lb in)

Rear Differential Clutch Control Module
Procedure
After the rear differential clutch control module has been replaced it must to be programmed. Refer to Control Module References .