Removal Procedure
WARNING:
WARNING:
- Raise and support the vehicle. Lifting and Jacking the Vehicle (ZL1)Lifting and Jacking the Vehicle (Convertible)
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
- Front Wheelhouse Splash Shield Replacement - Remove
Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Brake Hose Retainer (1) - Remove
Wheel Speed Sensor Wiring Harness Clip (1) @Brake Hose - Release[2x]
Bolt (1) - Remove
Brake Hose Fitting Bolt (1) - Remove
- NOTE:
Do not reuse the brake hose fitting gaskets.
Brake Hose Fitting Gasket (1) [2x]@Front Brake Hose (2) - Remove and DISCARD
- Front Brake Hose - Remove