Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Brake Pedal (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Clutch Pedal Bracket Bolt (1) - Install and tighten[3x]20 N.m (15 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Clutch Master Cylinder Bolt (1) - Install[2x]
Courtesy of GENERAL MOTORS COMPANY

Clutch Master Cylinder Nut (1) - Install and tighten[2x]13 N.m (115 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake and Clutch Pedal Assembly (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Nut (1) - Install and tighten[2x]25 N.m (18 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Power Vacuum Brake Booster Nut (1) - Install and tighten[2x]25 N.m (18 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Hydraulic Clutch Hose/Pipe (2) @Clutch Master Cylinder - Connect - Hydraulic Clutch Hose/Pipe Replacement (M13)Hydraulic Clutch Hose/Pipe Replacement (MJK, MM6)
Courtesy of GENERAL MOTORS COMPANY

Clutch Master Cylinder Feed Hose Grommet (1) - Secure
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Pushrod Retainer (1) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the brake pedal pushrod retainer is fully seated in the power vacuum brake booster pushrod.

Brake Pedal (1) - Secure
Reposition the electrical harness to the brake pedal and secure the harness retainers.
Clutch Pedal Position Sensor - Install - Clutch Pedal Position Sensor Replacement
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Position Sensor (1) - Install - Brake Pedal Position Sensor Replacement
Body Control Module Bracket - Install - Body Control Module Bracket Replacement
Courtesy of GENERAL MOTORS COMPANY

Clutch Master Cylinder Feed Hose (1) - Connect
Fill the master cylinder reservoir. Brake Master Cylinder Reservoir Filling
Bleed the hydraulic clutch system. Hydraulic Clutch System Bleeding