Removal Procedure
WARNING:
Refer to Brake Fluid Irritant Warning .
CAUTION:
Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
- Using a suitable tool, remove and properly discard the brake fluid from the master cylinder reservoir.
- Remove the brake fluid level indicator switch. Brake Fluid Level Indicator Switch Replacement
- Plenum Front Panel - Remove - Plenum Front Panel Replacement (LTG LGX)Plenum Front Panel Replacement (LT1 LT4)
- If equipped, disconnect the clutch master cylinder feed hose.
Remove the master cylinder reservoir bolt (1).
Lift the master cylinder reservoir (1) upward to release the reservoir from the reservoir seals and the master cylinder.
Remove the 2 master cylinder reservoir seals (1).