Rear Seat Cushion Removal and Installation

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
1	Rear Seat Cushion Procedure Insert a 457 mm (18 in) prybar next to the inboard side of each wire loop (a) and push down, using the floor as leverage, to disengage the retainers. If equipped, disconnect the rear seat wiring harness electrical connectors. Pull up on the front of the seat cushion. Push down on the rear of the seat to unhook the cushion wire from the lower cross bar hinges and remove from vehicle. Inspect each high retention retainer (2) and sheet metal interface for flushness. Replace retainer as required if damage occurs during removal. When installing new plastic retainers (2) on the front of the seat, ONLY seat the retainer to the first click, otherwise the insertion force into the sheet metal will be greatly increased.

Callout

Component Name

Rear Seat Cushion

Procedure

Insert a 457 mm (18 in) prybar next to the inboard side of each wire loop (a) and push down, using the floor as leverage, to disengage the retainers.
If equipped, disconnect the rear seat wiring harness electrical connectors.
Pull up on the front of the seat cushion.
Push down on the rear of the seat to unhook the cushion wire from the lower cross bar hinges and remove from vehicle.
Inspect each high retention retainer (2) and sheet metal interface for flushness. Replace retainer as required if damage occurs during removal.
When installing new plastic retainers (2) on the front of the seat, ONLY seat the retainer to the first click, otherwise the insertion force into the sheet metal will be greatly increased.