Windshield Garnish Molding Replacement - Left Side (Convertible)

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedure Place the folding top assembly in a full down position to allow access to the windshield side garnish molding.
1	Windshield Garnish Molding Procedure Starting at the top, gently pull on the garnish molding to disengage the clips. {If equipped} Disconnect the electrical connector. Transfer components as necessary. Garnish clips must be seated in roof front header garnish molding lower prior to installing sealing clips. NOTE: Tabs to be fully seated in instrument panel trim pad.

Callout

Component Name

Preliminary Procedure
Place the folding top assembly in a full down position to allow access to the windshield side garnish molding.

Windshield Garnish Molding

Procedure

Starting at the top, gently pull on the garnish molding to disengage the clips.
{If equipped} Disconnect the electrical connector.
Transfer components as necessary.
Garnish clips must be seated in roof front header garnish molding lower prior to installing sealing clips.

NOTE:

Tabs to be fully seated in instrument panel trim pad.