LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System - Repair Instructions >> Repair Instructions >> Front Headlamp Replacement (HID, ZL1)

Front Headlamp Replacement (HID, ZL1)

GM4168905Courtesy of GENERAL MOTORS COMPANY
NOTE: Callouts items in the following chart represent components shown in graphic above.
Callout Component Name
WARNING:

The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system.

WARNING:

The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:

  • Never open the high intensity discharge system ballast or the arc tube assembly starter.
  • Never probe between the high intensity discharge system ballast output connector and the arc tube assembly.

Preliminary Procedures

  1. Front Bumper Fascia Replacement (Base, Uplevel) , or Front Bumper Fascia Replacement (ZL1) , or Front Bumper Fascia Replacement (SS)
  2. Disconnect the electrical connectors.
1 Headlamp Bolt [4x]
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
2 Headlamp

Procedure

  1. Transfer components as necessary.
  2. After installation, aim the front headlamps. Front Headlamp Aiming 
scientia non olet · About LEMON Manuals