LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Automatic Trans >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Camaro LS, Automatic Trans, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All1.8B
Front,Both Sides1.00.8B
Rear,Both Sides1.00.7B
Combination Procedure: BRAKE HOSE: Replace:
Each Additional0.2B
OneIncludes: Perform ABS Automated Bleed procedure.0.7B
Combination Procedure: CALIPER: Overhaul:
One,Four Piston CaliperIncludes: Perform ABS Automated Bleed procedure.1.5B
One,Single Piston Caliper,FrontIncludes: Perform ABS Automated Bleed procedure.0.9B
One,Single Piston Caliper,RearIncludes: Calibration. Includes: Perform ABS Automated Bleed procedure.1.1B
One,Six Piston CaliperIncludes: Perform ABS Automated Bleed procedure.1.9B
Combination Procedure: CALIPER: Replace:
One,FrontIncludes: Perform ABS Automated Bleed procedure.0.7B
One,Rear,4 Piston CaliperIncludes: Perform ABS Automated Bleed procedure.0.7B
One,Rear,Single Piston CaliperIncludes: Calibration. Includes: Perform ABS Automated Bleed procedure.0.9B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,EachCorrect Rotor lateral runout by indexing or correction plate.0.2B
Combination Procedure: DISC ROTOR (REMOVED): Refinish:
DOES NOT include grind hot spots.
Each Additional0.3B
One0.5B
Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable:
Parking Brake Service ModeIncludes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. Includes: Electronic Parking Brake System Calibration.0.2B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,EachClean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.0.2B
Combination Procedure: PARKING BRAKE SHOE & LINING: Replace:
Each SideIncludes: Adjustment.0.4B
Combination Procedure: WHEEL BEARING: Replace:
Front,Hub & Bearing Assy,One Side0.4B
Rear,Hub & Bearing Assy,One Side0.6B