LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Bolt EV >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Master Cylinder Reservoir Replacement >> Installation Procedure

Installation Procedure

  1. Brake Fluid Level Indicator Switch@Brake Master Cylinder Reservoir - Install - Brake Fluid Level Indicator Switch Replacement 
  2. GM4530357Courtesy of GENERAL MOTORS COMPANY

    Lubricate the brake master cylinder reservoir seals with GM approved brake fluid from a clean, sealed, brake fluid container.

  3. Brake Master Cylinder Reservoir Seal (2) @Brake Master Cylinder (3) - Install NEW [2x]
  4. Brake Master Cylinder Reservoir (1) @Brake Master Cylinder (3) - Install
  5. GM4530356Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Brake Master Cylinder Reservoir Pin (1) @Brake Master Cylinder Reservoir (3) - Install and tighten 7 N.m (62 lb in)

  6. GM4530355Courtesy of GENERAL MOTORS COMPANY

    Body Wiring Harness (2) @Brake Master Cylinder Reservoir (3) - Install

  7. Clip (1) @Brake Master Cylinder Reservoir (3) - Install [2x]
  8. GM4530353Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) @Brake Fluid Level Indicator Switch (2) - Connect

  9. Engine Control Module@Vehicle - Install - Engine Control Module Replacement
  10. Bleed the brake system. Hydraulic Brake System Bleeding 
scientia non olet · About LEMON Manuals