Front Side Door Sill Garnish Molding Replacement

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedure 1. Instrument Panel Outer Trim Cover Replacement 2. When replacing the driver side front side door sill garnish molding, remove the hood primary latch release cable handle. Hood Primary Latch Release Cable Handle Replacement
1	Front Side Door Sill Garnish Molding Procedure Starting at the rear of the garnish molding, pull upward at the B-Pillar joint to disengage garnish molding. Work your way forward disengaging all of the garnish molding clips then pull rearward to disengage the clip on the forward vertical wall. Reposition the door weatherstrip as needed. Replace the retainers as required.

Callout

Component Name

Preliminary Procedure
1. Instrument Panel Outer Trim Cover Replacement
2. When replacing the driver side front side door sill garnish molding, remove the hood primary latch release cable handle. Hood Primary Latch Release Cable Handle Replacement

Front Side Door Sill Garnish Molding

Procedure

Starting at the rear of the garnish molding, pull upward at the B-Pillar joint to disengage garnish molding.
Work your way forward disengaging all of the garnish molding clips then pull rearward to disengage the clip on the forward vertical wall.
Reposition the door weatherstrip as needed.
Replace the retainers as required.