Liftgate Adjustment
 Courtesy of GENERAL MOTORS COMPANY
|
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout |
Component Name |
| 1 |
Liftgate
Procedure
- Loosen the four liftgate hinge bolts to adjust the liftgate.
- Adjust the liftgate in order to obtain an even gap between the liftgate and the roof, the quarter applique and the rear bumper fascia.
Adjustment
- Liftgate to roof (a) 5.5 mm ± 1.0 mm (0.22 in ± 0.04 in)
- Quarter applique to body side (b) 4.5 mm ± 1.2 mm (0.18 in ± 0.05 in)
- Liftgate to rear bumper fascia (c) 5.0 mm ± 1.25 mm (0.19 in ± 0.05 in)
- Liftgate to rear bumper fascia (d) 5.5 mm ± 1.25 mm (0.20 in ± 0.05 in)
Tighten
22 N.m (16 lb ft) |