Hood Adjustment
 Courtesy of GENERAL MOTORS COMPANY
|
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout |
Component Name |
| 1 |
Hood
Procedure
- Loosen the four hood hinge bolt.
- Adjust the hood in order to obtain an even gap on both sides between the hood and the A-pillar, the fender applique, the headlamp and the grille.
Adjustment
- Hood to A-pillar (a) 3.0 mm ± 1.0 mm (0.12 in ± 0.04 in)
- Hood to fender applique (b) 3.0 mm ± 0.75 mm (0.12 in ± 0.03 in)
- Hood to headlamp (c) 3.0 mm ± 0.9 mm (0.12 in ± 0.035 in)
- Hood to grille (d) 6.0 mm ± 1.0 mm (0.24 in ± 0.04 in)
Tighten
22 N.m (16 lb ft) |