LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (2 Of 5)) >> Diagnostic Information and Procedures >> DTC P037A, P037B, or P0381 - Wait to Start Lamp Diagnosis >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Verify the ignition fuse that supplies voltage to the component is not open: P16 Instrument Cluster
    • If the fuse is open 
    1. Ignition/Vehicle - Off
    2. Disconnect the electrical connector: P16 Instrument Cluster
    3. Test for infinite resistance between the test points: Ignition circuit terminal 8 & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: P16 Instrument Cluster
    • Go to next step: If the fuse is not open 
  2. Ignition/Vehicle - Off
  3. Disconnect the appropriate electrical connector: K20 Engine Control Module
  4. Ignition - On / Vehicle - In Service Mode
  5. Verify the component works as specified: Wait to Start Indicator = Off
    • If the component does not work as specified 
    1. Ignition/Vehicle - Off
    2. Test for infinite resistance between the test points: Control circuit terminal 28 X1 & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: P16 Instrument Cluster
    • Go to next step: If the component works as specified 
  6. Ignition/Vehicle - Off
  7. Connect a 3 A fused jumper wire between the test points: Control circuit terminal 28 X1 & Ground
  8. Ignition - On / Vehicle - In Service Mode
  9. Verify the component works as specified: Wait to Start Indicator = On
    • If the component does not work as specified 
    1. Ignition/Vehicle - Off & Remove - Jumper wire (s)
    2. Disconnect the appropriate electrical connector: P16 Instrument Cluster
    3. Ignition - On / Vehicle - In Service Mode
    4. Test for less than 1 V between the test points: Control circuit terminal 28 X1 @ Control module harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • Go to next step: If less than 1 V
    5. Ignition/Vehicle - Off
    6. Test for less than 2 ohms between the test points: Control circuit terminal 32 X1 @ Component harness & The other end of the circuit @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • Go to next step: If less than 2 ohms
    1. Test for less than 2 ohms between the test points: Ignition circuit terminal 8 @ Component harness & Output terminal @ Fuse
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: P16 Instrument Cluster
    • Go to next step: If the component works as specified 
  10. Replace the component: K20 Engine Control Module
scientia non olet · About LEMON Manuals