LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (2 Of 5)) >> Diagnostic Information and Procedures >> DTC P0340 or P0341 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0340 Condition 1 

Camshaft Position Sensor = No Signal - For greater than 5.5 s

Condition 2 

Camshaft Position Sensor = No Signal - For greater than 4 s - Starter is engaged.

Condition 3 

Camshaft Position Sensor = Less than 4 pulse (s) - For greater than 3 s

Condition 4 

Camshaft Position Sensor = No Signal - During the first 1 engine revolutions.

Condition 5 

Camshaft Position Sensor = No Signal - During 100 engine revolution (s)

P0341 Condition 1 

Camshaft Position Sensor = Less than 4 pulse (s) - During 1 engine revolution (s)

Condition 2 

Camshaft Position Sensor = Greater than 6 pulses - During 1 engine revolution (s)

Condition 3 

Camshaft Position Sensor = Less than 398 pulse (s) - Greater than 402 pulses - During 100 engine revolution (s)

scientia non olet · About LEMON Manuals