Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0335 Condition 1
- DTC P0101, P0102, P0103 = Not set
- MAF Sensor = Greater than 2.0 g/s
Condition 2
- M64 Starter Motor = Active
- Camshaft Position Sensor = Signal received
Condition 3
- M64 Starter Motor = Inactive
- Engine = Running
Condition 4
- DTC P0340, P0341 = Not set
- Engine = Running
Condition 5
- DTC P0340, P0341 = Not set
- M64 Starter Motor = Active
Frequency the DTC runs = Continuously - After the running conditions are met
P0336 Condition 1
- DTC P0335 = Not set
- Engine Speed = Greater than 450 RPM
- MAF Sensor = Greater than 2.0 g/s
Condition 2
- M64 Starter Motor = Inactive
- Engine = Running
Condition 3
- DTC P0101, P0102, P0103 = Not set
- MAF Sensor = Greater than 2.0 g/s
Condition 4
- M64 Starter Motor = Active
- Camshaft Position Sensor = Signal received
Condition 5
- DTC P0340, P0341 = Not set
- Engine = Running
Condition 6
- DTC P0340, P0341 = Not set
- M64 Starter Motor = Active
Frequency the DTC runs = Continuously - After the running conditions are met