Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P026E, P10BA, P2B83, P2B84

Ignition and Start Switch Signal = On
Ignition and Start Signal = Greater than 11 V
Engine Coolant Pump Speed = Commanded On
Charge Air Cooler Coolant Pump Speed = Greater than 1, 000 RPM
Engine Coolant Temperature = 40 to 104°C (126 to 258°F)

Frequency the DTC runs = Continuously - After the running conditions are met

P30AE, P30AF

DTC U02A9 = Not set
Ignition and Start Switch Signal = On - Engine Running
Ignition and Start Signal = Greater than 11 V

Frequency the DTC runs = Continuously - After the running conditions are met

U02A9, U05AA

Ignition and Start Switch Signal = On
Ignition and Start Signal = Greater than 11 V
Power Mode = Run

Frequency the DTC runs = Continuously - After the running conditions are met