LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (1 Of 5)) >> Diagnostic Information and Procedures >> DTC P017B-P017D, P117F, P14C0, or P2C3A-P2C3D >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the following scan tool parameters are within the specified range: -39 to 139°C (-38 to 282°F)
    • Cylinder Head Temperature Sensor
    • Cylinder Head Temperature Sensor 2
    • If not in the specified range 

      Refer to: Circuit/System Testing

    • Go to next step: If in the specified range 
  3. Verify the scan tool parameter:
    • Cylinder Head Temperature Sensor = The value should not spike or drop out.
    • Cylinder Head Temperature Sensor 2 = The value should not spike or drop out.
    • Perform the action while monitoring the parameter:
    • Wiggle the harness and connector: B96 Cylinder Head Temperature Sensor
    • Wiggle the harness and connector: @ K20 Engine Control Module
    • If the value spikes or drops out 

      Repair as necessary - Wiring / Terminal (s) / Electrical Connector (s)

    • Go to next step: If the value does not spike or drop out 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals