Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P262B is not set.
- If the DTC is set
- Go to next step: If the DTC is not set
- Verify there are no DTCs set related to the following component/system:
- B9 Ambient Air Temperature Sensor
- B17 Barometric Pressure Sensor
- B34 Engine Coolant Temperature Sensor
- B66 Intake Air Temperature Sensor
- B115 Vehicle Speed Sensor
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If no DTC is set
- If the DTC sets
- All OK.