LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Cylinder Leakage Test >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5612781Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

    NOTE:

    The ceramic glow plug technology is sensitive to collision, drops, or general impact Avoid side force or the bending of the tip during the installation in the head. Replace the glow plug if one or more of these conditions is suspected.

    NOTE:

    Do not use power tools to install glow plugs.

    Glow Plug (1) - Install and tighten [6x] - Fastener Specifications

  2. GM5148358Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) @ Glow Plug - Connect [6x]

  3. GM5612777Courtesy of GENERAL MOTORS COMPANY

    Throttle Body Gasket (3) - Install NEW

  4. Throttle Body (2) - Install
    5. CAUTION:

    Refer to Fastener Caution .

  5. Throttle Body Bolt (1) - Install and tighten [3x] - Fastener Specifications
  6. Connect the throttle body electrical connector.
  7. GM5211335Courtesy of GENERAL MOTORS COMPANY

    Charge Air Cooler Outlet Air Hose (2) - Install

  8. Charge Air Cooler Outlet Air Hose Clamp (1) - Tighten [2x] - Fastener Specifications
  9. Oil Filler Cap - Remove
  10. GM5171779Courtesy of GENERAL MOTORS COMPANY

    Intake Manifold Cover (2) - Install

  11. Intake Manifold Cover Bolt (1) - Install and tighten - Fastener Specifications
  12. Oil Filler Cap - Install
scientia non olet · About LEMON Manuals