Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Emission Reduction Fluid Controller (2) - Install
- Emission Reduction Fluid Controller Bolt (1) - Install and tighten [2x] - Fastener Specifications
Electrical Connector (1) - Connect
Emission Reduction Fluid Tank Shield (2) - Install
- Emission Reduction Fluid Tank Protector Bolt (1) - Install and tighten [4x] - Fastener Specifications
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Install
- Retainer (3) - Install
- Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Connect - Plastic Collar Quick Connect Fitting Service
- Electrical Connector (1) - Connect
Emission Reduction Fluid Tank Protector (2) - Install
- Retainer (1) - Install
Emission Reduction Fluid Tank Heat Shield (1) - Install
Emission Reduction Fluid Tank Heat Shield Retainer (1) - Install [2x]
Emission Reduction Fluid Tank Heat Shield Retainer (1) - Install [4x]
- Lower the vehicle.
- It is necessary to reprogram the replacement module. Control Module References
CAUTION:
Refer to Fastener Caution .