Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe Insulator (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) - Disconnect - Plastic Collar Quick Connect Fitting Service
Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner Bolt-Right Side (1) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner Bolt-Right Side (1) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner-Right Side (1) - Reposition
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Number of retainers may vary.

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Retainer (2) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Number of retainers may vary.

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Retainer (2) - Remove [5x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Number of retainers may vary.

Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (1) @ Retainer (2) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Retainer (1) - Remove
Emission Reduction Fluid Tank Protector (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Disconnect
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
Retainer (3) - Remove
Emission Reduction Fluid Exhaust Front Pipe Injector Supply Pipe (2) - Remove