LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (2 Of 2)) >> Repair Instructions >> Cylinder Head Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Oil Filler Cap - Remove
  2. GM5171779Courtesy of GENERAL MOTORS COMPANY

    Intake Manifold Cover Bolt (1) - Remove

  3. Intake Manifold Cover (2) - Remove
  4. Install the oil filler cap after removal of the intake manifold cover (2) to prevent debris from falling into the engine.
  5. GM5499646Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness Bracket Nut (1) - Remove [2x]

  6. Engine Wiring Harness Bracket Bolt (2) - Remove
  7. Engine Wiring Harness Bracket (3) - Reposition
  8. GM5615269Courtesy of GENERAL MOTORS COMPANY

    Disconnect the cylinder head temperature sensor electrical connector (1).

  9. GM5144300Courtesy of GENERAL MOTORS COMPANY

    Cylinder Head Temperature Sensor (1) - Remove

scientia non olet · About LEMON Manuals