Cylinder Head Bolt Sequence
WARNING: This page is about a different variant/trim than selected.
| Cylinder Head Bolt Sequence | |||||
|---|---|---|---|---|---|
| Callout | Component Name [Component Quantity] | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
| Metric (English) | |||||
| 1 | Cylinder Head Bolt [14x] | Yes | - | First Pass: Tighten all bolts to 40 N.m (30 lb ft) Second Pass: Loosen bolts (13, 14, 5, 6, 4, 3, 11, 12) completely. Third Pass: Tighten bolts (13, 14, 5, 6, 4, 3, 11, 12) to 40 N.m (30 lb ft) Fourth Pass: Loosen bolts (9, 10, 1, 2, 7, 8) completely. Fifth Pass: Tighten bolts (9, 10, 1, 2, 7, 8) to 40 N.m (30 lb ft) Sixth Pass: Tighten all bolts to 80 N.m (59 lb ft) Final Pass: Using EN-45059-A Angle Meter, tighten all bolts in sequence 225 degrees |
Cylinder Head Replacement |