Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter: Water in Fuel = No
- If not the specified state
Refer to: Circuit/System Testing
- Verify the condition does not exist: Water @ Fuel Filter Water Bleed Screw
Refer to: Water-in-Fuel Draining
- If a condition exists - Refer to: Contaminants-in-Fuel Diagnosis
- If no condition exists - Refer to: DTC P2264 or P2269
- Go to next step: If the specified state
- If not the specified state
- All OK.