Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine - Cranking - For 10 s
Verify the function: Engine = Running
- If the function does not work
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the function works
- If the function does not work
- Ignition/Vehicle - Off
- Verify the condition does not exist: Fuel - Contaminated/Poor Quality - Refer to: Contaminants-in-Fuel Diagnosis
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Engine - Running
Verify the following conditions do not exist:
- Engine - Misfire/Reduced Engine Power/Stalling
- Engine Speed - Rough/Unstable
- Exhaust - Excessive Smoke
- If a condition exists
Refer to: Circuit/System Testing - Test 2
- Go to next step: If no condition exists
- Refer to: Symptoms - Engine Controls
NOTE:
Do NOT perform this procedure unless directed here from another procedure.