Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P2264

DTC P1103, P16D7, P16D8, P16D9, P262B = Not set
Ignition and Start Switch Signal = On - For less than 2 s
Ignition Off Time = Greater than 1 min
Ignition and Start Signal = Greater than 11 V

Frequency the DTC runs = Once - Per drive cycle - After the running conditions are met

P2269

DTC P1103, P16D7, P16D8, P16D9, P262B = Not set
Ignition and Start Switch Signal = On - For greater than 15 s
Ignition and Start Signal = Greater than 11 V

Frequency the DTC runs = Continuously - After the running conditions are met