Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P2264, P2269 is not set and no other DTCs are set.
- If DTC 2264 is set and other DTCs are set
Refer to: Circuit/System Testing
- If DTC P2269 is set and no other DTCs are set
- Verify the condition does not exist: Water @ Fuel Filter Water Bleed Screw
- If a condition exists - Refer to: Water-in-Fuel Draining
- If no condition exists - Refer to: Circuit/System Testing
- Go to next step: If none of the DTCs are set
- If DTC 2264 is set and other DTCs are set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.