Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P2227 Condition 1
The following parameters are not within 46 kPa (6.7 PSI) of each other:
- Barometric Pressure Sensor
- Barometric Pressure Sensor 2
- Manifold Absolute Pressure Sensor
Condition 2
Barometric Pressure Sensor = Not between 50 and 115 kPa (7 and 17 PSI)
Condition 3
The following parameters are not within 10 kPa (1.5 PSI) of each other:
- Barometric Pressure Sensor
- Barometric Pressure Sensor 2
- Manifold Absolute Pressure Sensor
The above condition(s) must occur for greater than 1 s.
P2228
Signal circuit = Less than 45 kPa (6.5 PSI) - For greater than 5 s
P2229
Signal circuit = Greater than 115 kPa (16.7 PSI) - For greater than 5 s
P2230
Signal circuit = Signal noisy or erratic - For greater than 5 s