Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P205B

DTC P10F4, P205C, P205D, P205E, P20FF, U010E, U2412, U2626 = Not set
Ignition Off Time = For greater than 8 h
Ignition = On
Ignition and Start Switch Signal = Greater than 11 V

Frequency the DTC runs = Once - Per ignition cycle - After the running conditions are met

P205C, P205D

DTC P10F4, P20FF = Not set
Ignition = On
Ignition and Start Switch Signal = Greater than 11 V

Frequency the DTC runs = Continuously - After the running conditions are met

P205E

DTC P10F4, P205C, P205D, P20FF = Not set
Ignition = On
Ignition and Start Switch Signal = Greater than 11 V

Frequency the DTC runs = Continuously - After the running conditions are met