LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2022 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (4 Of 5)) >> Diagnostic Information and Procedures >> DTC P200C >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition On.
  2. Verify there are no DTCs set related to the following component/system:
    • B9 Ambient Air Temperature Sensor
    • B17 Barometric Pressure Sensor
    • B34 Engine Coolant Temperature Sensor
    • B65 Intake Manifold Pressure and Air Temperature Sensor
    • B75C Multifunction Intake Air Sensor
    • B115 Vehicle Speed Sensor
    • B131B Exhaust Temperature Sensor 2
    • B136 Exhaust Particulate Matter Sensor
    • B195A Nitrogen Oxides Sensor 1
    • Q14 Exhaust Gas Recirculation Valve
    • Q17 Fuel Injector
    • Go to next step: If a related DTC is not set 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions identified from the Freeze Frame/Failure Records data.
  4. Verify DTC P200C is not set.
    • If the DTC is set 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC is not set 
  5. All OK.