Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On / Vehicle - In Service Mode
Verify DTC P10C1, P10EC, P10ED, P2006, P2008, P2010, P2016, P2017, P201B, P20F8, U064F is not set.
- If the DTC is set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If the DTC is not set
Clear the DTCs.
Ignition Off - For greater than 1 min
Ignition - On / Vehicle - In Service Mode
Verify DTC P200A is not set.
- If the DTC sets
1. Ignition/Vehicle - Off
2. Remove - Intake Manifold
3. Verify the following conditions do not exist: Blade @ Q22 Intake Manifold Tuning Solenoid Valve
  - Binding or Sticking @ Open/Close - Position
  - Closed @ Engine Off
  - Coking/Debris / Dirty / Visible Damage
  - Open/Close - Without spring pressure
    Refer to: Intake Manifold Replacement
  - If a condition exists - Repair or replace as necessary
- Go to next step: If the DTC does not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Repeat step 2
- Go to next step: If the DTC does not set
All OK.